Jacket "Storm" V. 2 Membrane

High-strength membrane (HardShell) jacket. Adapted for use by armed professionals, but can also be used for outdoor activities

Attention! This jacket is not the sixth layer of military multi-layer clothing systems (a lightweight and simplified set transported in a backpack in case of precipitation), but is a full-fledged product by design for permanent wear. The hood is not designed for use with a helmet

A loose fit that takes into account the possibility of wearing over warm thermal underwear and a fleece jacket

Reinforcements from Cordura® 320d in places subject to wiping are not overlays on the main fabric, but are used instead of it, having the same membrane on the wrong side

All external zippers are tractor splash — proof. Unlike the common splash-proof twisted ones, they have greater strength and are much easier to unbutton (including at very low temperatures). The locks are equipped with convenient handles made of braid

A particularly strong nylon thread COATS Nylbond is used (designed for equipment). All the main seams have additional stitching. The loaded sections are reinforced with zigzag fasteners . All seams are taped

Raglan sleeve, articulated cut. The shoulders and elbows to the wrists are reinforced with Cordura®fabric. Flat sleeve pockets with a vertical zipper entrance. Velcro fasteners for attaching chevrons (10x15 cm) are made of a special soft velcro cloth by laser cutting, their edges are not scratched, and they do not stick out due to rigidity

Under the armpits are long two-lock ventilation zippers, unfastened from the center to the ends

The cuffs are adjustable with Velcro patches

The central zipper is of a large type, two — lock. The zipper is covered with a bar from the inside to the full height. In the neck area, the plank is trimmed with velour for comfort, a bend on top to protect the chin. At the bottom of the wrong side there is a button closure that removes the load from the zipper

The collar and hood are a single whole. Taped visor with a hard plastic insert sewn on the edge to maintain the shape. The hood is adjustable in two dimensions by an elastic cord with Duraflex ® clamps: a tie around the face (the extra ends of the cord are brought to the wrong side of the collar base) and a back tie around the head. A hanger is sewn into the back outside of the base of the collar

Chest pockets with an entrance with an inclined zipper on the sides of the trunk. The pockets are not blocked by the belts of RPS and backpacks, the entrance is available when wearing a bulletproof vest, unloading vest or bib

A small (fits a Russian passport) inner pocket on the left side of the chest, on a thin twisted vertical zipper, mesh burlap

The bottom of the jacket is pulled by an elastic cord with adjustable Duraflex ® latches on the sides

Materials:

Main fabric:

• 100% nylon, 140dx320d
• The density of the material is 189 g/^m2
• Hydrophilic PU membrane, three-layer (3L) construction
• Water resistance — 10000 mm of water column
• Vapor permeability-10000 g/m ^2/24 h (according to the B1 method)
• Water-repellent DWR surface treatment

Reinforcing fabric:

• 100% nylon, Cordura® 320d
• The material density is 220 g/^m2
• Hydrophilic PU membrane, three-layer (3L) construction. Similar to the main fabric
• Water resistance — 10000 mm of water column
• Vapor permeability-10000 g/m ^2/24 h (according to the B1 method)
• Water-repellent DWR surface treatment