Combat Trousers "Combat Pant"

A belt with a high waist at the back. The back half of the belt is reinforced with a thin semi-rigid foam to maintain shape and comfort during prolonged wear. The foam has a perforation for ventilation. The belt is rubberized on the sides, the elastic tie is regulated by thin patches of Velcro tape

The belt is fastened with a wide Velcro in the front, which allows you to avoid bulging accessories that press on the body under the belt and unloading belts. Six large belt loops for the trouser belt (up to 50 mm wide inclusive), on the front pair from below there are loops for attaching safety cords, retractors, carabiners, etc.

A codpiece with a zipper

The gusset for freedom of movement and protection from rubbing the trousers on the inner surface of the thighs, is made of elastic material

The seat area is reinforced with a lining made of the main fabric

The elastic insert on the lower back makes it easier to bend and does not allow the belt to slide

Articulated knees with elastic inserts that allow the knee pads to remain in the same position on the knees, without lifting up when bending the leg. Reinforcing pads on the knees made of the main fabric. At the bottom of the reinforcements there is a slot for water drainage

On the knee reinforcement there is a window for installing a knee pad, sheathed from the inside along the perimeter with Velcro. In the absence of a knee pad, the window is closed with a plug sewn inside from the main fabric

Behind the knees, two Velcro patches are symmetrically located, allowing you to adjust the circumference of the knee pads around the leg

Adjustment of the height of the position of the knee pads to fit the desired height is carried out using a hidden elastic cord. The ends of the cord are displayed in the small front patch pockets. When pulling the cord, the knee pad rises

The trousers are compatible with the original knee pads with the PrecisionTMAirflexTMCombat Knee Pads and other analogues. Protect knee pads are included with the trousers

Side undercut pockets with an open entrance

Large cargo pockets with vertical folds to create additional volume, with two Velcro flaps. Inside are sewn flat pockets for small things (internal organization)

Small pockets on the calves with a vertical fold to create additional volume, with two Velcro flaps. Well-suited for carrying PPI, convenient access in a sitting position

Small pockets on the front surface of the thighs are a copy of the pockets on the calves. Inside, under the valves, there is a height adjustment of the position of the knee pads

The bottom of the trousers is tightened with a Velcro patch. It is recommended to wear over shoes

At the bottom of all the pockets there is one swept loop for water drainage

The loaded sections are reinforced with zigzag fasteners

Materials:

• Main fabric: NYCO Rip-stop , 50% cotton, 50% nylon. The density is 220 g/^m2. Standard mixed fabric for summer military uniforms. It surpasses the more common version of polyester and cotton in a number of parameters. With water-repellent DWR surface treatment
• Elastic inserts: non-insulated softshell, 92% nylon, 8% spandex. The density is 264 g/^m2. Special double Weave with a dense and resistant to external influences upper layer and comfortable to the body inner layer of thicker and looser fibers. Elasticity in both directions. With water-repellent DWR surface treatment
• Knee pads: foamed ethylene vinyl acetate, 100% polyester knitwear, thermoplastic rubber
• Plastic accessories: Duraflex®